Dramatically improves response time of 24V solenoids in high
Built-in fast flux decay circuit quick turn-off.
LED status indicator.
Compact size. DIN rail or panel mount.
Regent’s 5 Year “No-Questions-Asked” Warranty.
Glue gun control
Bag punching solenoids
Faulty product ejectors
The PR11OE24 is a solid-state over-energization
power supply relay for 24 VDC loads. By applying an initial over-voltage,
turn-on times of typical loads can be reduced by up to 75%. By reducing
the load response time, cycle rates in high-speed applications can be
In addition to solenoid valves, the PR11OE24 can be used to rapidly energize
wrap-spring clutch solenoids. An added benefit is improved turn-on consistency.
Upon initiation, the PR11OE24 supplies 150 VDC (peak) to the load, resulting
in fast energization. Following over-energization, the solid-state output
pole remains ON. Customer-supplied 24 VDC keeps the load energized.
The PR11OE24’s fast flux decay circuit provides fast turn-off of
the load when the initiate signal is removed. No protective components
are needed with inductive loads.
TYPICAL SOLENOID VALVE RESPONSE TIMES
9 msec 3.5 msec
6 msec 2 msec
8 msec 2 msec
1. Initiating contact may be any switch, transistor, photo or proximity
sensor, or PLC output capable of switching 10 mA at 24 VDC. Current sourcing
or sinking can be used.
2. Load must not be grounded. Terminal 2 may be grounded if connected
to a separate 24 VDC power supply.
3. Turn-off time can be reduced by installing a resistor between 24 VDC
supply and +24 IN terminal to reduce holding current. Initial over-energization
voltage will not be affected.