“In-series” design for easy application with simplified
wiring.
Fast reset time—less than 0.02 sec.
Calibrated direct-reading linear dial.
Controls any relay, contactor, solenoid, or motor starter through
NEMA size 2.
Compact size. DIN rail or panel mount.
Fixed time and remote time-setting options.
Regent’s 5 Year “No-Questions-Asked” Warranty.
Ideal for:
Packaging machinery
Printing presses
Filling machines
Molding presses
Solenoid valve control
Heat sealing
Rubber machinery
Forming presses
Weighing systems
Repetitive gluing
Regent’s TM301 is an all-solid-state two-terminal delay timer
designed for operation in series with 6 mA to 1 amp, 120 VAC relays
and other industrial loads.
The TM301 provides exceptionally stable, repeatable timing from 0.05
sec. to 5 min. for applications where conventional timers using synchronous
motors, pneumatics, or relays are inaccurate, subject to breakdown,
or have short service life in high-speed automatic control systems.
The control is supplied in a compact DIN-rail mount enclosure with
screw terminals. As an option, the time-adjusting potentiometer may
be remotely mounted.
Unlike similar timers that contain a miniature relay of inherently
short life, which defeats the reliability of solid-state circuitry,
the TM301 contains no relay. This assures precise, trouble-free timing
for dependable high-duty-cycle applications.
DIMENSIONS
WIRING DIAGRAM
Maintained Initiating Contact
Momentary Initiating Contact
OPERATION (refer to WIRING DIAGRAMS):
MAINTAINED INITIATING CONTACT:
1. On closure of initiating contact, timing begins.
2. At the end of timing, the load (or CR1) is energized by the TM301. A
relay (CR1) with 120V coil connected as load will provide contacts with
time-delay-after-energization; they can be normally-open or normally-closed.
3. When the initiating contact is opened, the timer resets and the load
is de-energized. CR1 may be plug-in relay without use of paralleling resistor.
MOMENTARY INITIATING CONTACT:
1. On closure of initiating contact, timing begins and relay CR2 is energized,
thus providing a holding current around the initiating contact.
2. At the end of timing, the load (or CR1) is energized by the TM301 until
the interrupting contact is opened, resetting the timer and de- energizing
the load and CR2. Additional contacts on CR2 may be used as instantaneous
contacts.
NOTE
1. Specify Remote option (‘R’ time adjust feature, see part
number builder) if time adjustment potentiometer is to be mounted away
from timer. Connect remote potentiometer to terminals 3,4.
2. See Timer22/23 series for other timing modes.
SPECIFICATIONS
TM301
Line Input
120 VAC +/- 20%, 50/60 Hz max.
Load Rating
Voltage
Current
Recommended fuse
120 VAC +/- 20%
1 A continuous, 5 A inrush, inductive or resistive.
Any contactor, solenoid valve, or motor starter through NEMA
Size 2.
Buy Now 